不定期上传关于Mission Planner地面站的一些使用方法，体会，和大家分享。. 也会提出一些疑问，期待和大家一起探讨。. 教学：1分钟学会PPK后处理。. 静态测量：学会五步，包您学会静态测量。. 静态测量 3/5：外业操作，详解架设仪器、记录时段等。. GPS也能获取 The easiest way to check if the GPS is connected correctly is going to Status tab and check “gpsstatus”, which should be 1. The Mission Planner HUD reports NO GPS or GPS NO FIX; in the first case there is no GPS and in the second case there is GPS but it has not picked up satellites. But if the HUD shows the information as ICONS, in that Hi all, I am new to ArduPilot and Mission Planner. I have setup an RC vehicle with a Cube Orange and 2 HerePros. My goal is to setup GPS for Yaw with 2 HerePros. I have updated to the latest firmware on the Cube and the HerePros. I have followed the guidlines here [ GPS for Yaw (aka Moving Baseline) ](GPS for Yaw (aka Moving Baseline) — Copter documentation) with no success. As can be seen An Extended Kalman Filter (EKF) algorithm is used to estimate vehicle position, velocity and angular orientation based on rate gyroscopes, accelerometer, compass, GPS, airspeed and barometric pressure measurements. The advantage of the EKF over the simpler complementary filter algorithms (i.e. “Inertial Nav” or DCM), is that by fusing all Also set LOG_DISARMED to 1 this will start logging data before you arm the quad and you can provide a data flash log file for other analysis such as tuning and things when you fly. I highly suggest you take a look at the wiki. The fact that your gps says no fix instead of no gps is promising. GPS : NOT FIX - Ardupilot 2.8. Ground Control Software Mission Planner. ak96 (ak) November 17, 2018, 8:42pm #1. Hello, When I try to use my Ardupilot 2.8, I faced this problem. The gps is not fixed all the time. I tried to use it outdoor but no response. No Fix, 0 Sats. : r/Multicopter. Trouble setting up ublox M8Q-5883 GPS/compass module. No Fix, 0 Sats. Using this GPS module with the Matek F405-CTR. Wired the GPS to the UART1 on the board. In Mission Planner I get the message "GPS: No Fix" on the Data screen. Red light on on the GPS but blue light off. OpenDroneID Panel Edit on GitHub OpenDroneID Panel Mission Planner has a special Drone ID tab in its DATA view for use with OpenDroneID modules attached to the autopilot which allows monitoring status, attaching the required GPS for operator location of the GCS, and UAS and Operator ID string setup. Note Mission Planner: Live Compass Calibration Hold the vehicle in the air and rotate it slowly so that each side (front, back, left, right, top and bottom) points down towards the earth for a few seconds in turn. Installing APM Planner 2. APM Planner 2 is a ground control station based on the Qt cross-platform development framework. Currently it runs on Windows, Linux, Mac OS X. For platform-specific installation instructions, see the links below: Windows. Mac OSX. We264.